Re: CNC Lathes, follow rests, and mass production...
Posted by
Paul Huffman
on 2005-05-02 08:28:32 UTC
As stated, this could be dangerous. A follow rest only contacts the
material in two places and should basically be used with a center in
the tail stock. Might be possible to do if you could modify it to be
more like a steady with three point contact. I would be tempted to
just stick out enough material to run a few parts at a time.
Just my 2 cents.
Paul in OKC
material in two places and should basically be used with a center in
the tail stock. Might be possible to do if you could modify it to be
more like a steady with three point contact. I would be tempted to
just stick out enough material to run a few parts at a time.
Just my 2 cents.
Paul in OKC
Discussion Thread
babinda01
2005-05-01 02:42:45 UTC
Field wound DC Servo
Jon Elson
2005-05-01 08:00:08 UTC
Re: [CAD_CAM_EDM_DRO] Field wound DC Servo
babinda01
2005-05-01 14:25:11 UTC
Re: Field wound DC Servo
Jeff Albro
2005-05-01 19:06:09 UTC
CNC Lathes, follow rests, and mass production...
Bob Muse
2005-05-01 19:44:44 UTC
Re: [CAD_CAM_EDM_DRO] CNC Lathes, follow rests, and mass production...
Jon Elson
2005-05-01 19:56:01 UTC
Re: [CAD_CAM_EDM_DRO] Re: Field wound DC Servo
Jack
2005-05-01 20:27:08 UTC
Re: CNC Lathes, follow rests, and mass production...
metlmunchr
2005-05-02 07:48:45 UTC
Re: CNC Lathes, follow rests, and mass production...
Paul Huffman
2005-05-02 08:28:32 UTC
Re: CNC Lathes, follow rests, and mass production...
Jeff Albro
2005-05-05 04:03:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: CNC Lathes, follow rests, and mass production...
Fred Smith
2005-05-05 04:48:39 UTC
Re: CNC Lathes, follow rests, and mass production...
turbulatordude
2005-05-05 07:42:13 UTC
Re: CNC chucks for lathes
Fred Smith
2005-05-05 17:17:25 UTC
Re: CNC chucks for lathes