Re: Linear encoder outputs
Posted by
bazer_20002000
on 2005-07-01 12:51:52 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "philsumser" <phil.sumser@x>
wrote:
circuits section under files and find the file "analog output
encoder interface.pdf". I was in a similar situation and Mariss
kindly provided this suggestion.
Fred
I have yet to build the circuits having got halfway through and then
diverted onto another project
wrote:
> Greetings Allrecently
>
> Does anybody have an answer to the following problem. I have
> purchased some Acu-rite Turnmate scales which I intend to fit tomy
> lathe and milling machine. They are about 10 years old but arebrand
> new and still in their sealed packaging. My idea is to connect theact
> outputs of the scales into the serial or parallel port on a PC to
> as a DRO(I already have the software for this). The output of thecurrent at
> scales is analogue differential sinusoidal quadrature phase
> 7-18.5 micro amps into a 1Kohm load, but I need the usual 5v quadphase
> TTL signal for the computer. Does anybody know of a circuit I canbuild
> to effect this conversion?Phil if you need to interpolate between max and min go to the
>
> Best regards
>
> Phil Sumser
> New Zealand
circuits section under files and find the file "analog output
encoder interface.pdf". I was in a similar situation and Mariss
kindly provided this suggestion.
Fred
I have yet to build the circuits having got halfway through and then
diverted onto another project
Discussion Thread
philsumser
2005-06-29 22:29:45 UTC
Linear encoder outputs
Jon Elson
2005-06-30 09:38:16 UTC
Re: [CAD_CAM_EDM_DRO] Linear encoder outputs
Jymmm
2005-06-30 10:54:05 UTC
Re: Linear encoder outputs
Roy J. Tellason
2005-06-30 11:04:15 UTC
Re: [CAD_CAM_EDM_DRO] Linear encoder outputs
Roger Hampson
2005-06-30 13:28:26 UTC
RE: [CAD_CAM_EDM_DRO] Linear encoder outputs
bazer_20002000
2005-07-01 12:51:52 UTC
Re: Linear encoder outputs