new product announced > PMDX-135 power prep module
Posted by
Steve Stallings
on 2005-08-11 13:52:36 UTC
PMDX announces a new board to make building medium and large CNC
control systems easier. The PMDX-135 power preparation module
provides the functions of AC power rectify, DC filter, back EMF
load "DUMP", and safety discharge of filter caps upon power down.
This board is rated for up to 80 volts DC at 20 amperes continous
output, suitable for 4 Gecko stepper drivers running full current.
It will sell for $119.00 for the 80 volt version. A 50 volt version
is also planned at slightly lower cost.
For additional information please see our web site:
http://www.PMDX.com
We will have a sample unit on display at the Iron Fever show. Hope to
see many of you there.
Cheers,
Steve Stallings
PS - Thanks to Mariss for his suggestions about back EMF management
control systems easier. The PMDX-135 power preparation module
provides the functions of AC power rectify, DC filter, back EMF
load "DUMP", and safety discharge of filter caps upon power down.
This board is rated for up to 80 volts DC at 20 amperes continous
output, suitable for 4 Gecko stepper drivers running full current.
It will sell for $119.00 for the 80 volt version. A 50 volt version
is also planned at slightly lower cost.
For additional information please see our web site:
http://www.PMDX.com
We will have a sample unit on display at the Iron Fever show. Hope to
see many of you there.
Cheers,
Steve Stallings
PS - Thanks to Mariss for his suggestions about back EMF management