CAD CAM EDM DRO - Yahoo Group Archive

Re: EMC stepper & misc fixes

Posted by Tim Goldstein
on 1999-06-14 22:13:10 UTC
I downloaded and installed the new build with no problems tonight and had a
few minutes to play with it. The Verify button is a big improvement in my
mind as we can now at least parse through some code real quickly without
having to run the machine or start up a simulation. I played with using the
Run From Set Point as Matt suggested, but found that it was a little flaky
about starting at my chosen point. Seemed to work sometimes and not others.
The Verify button seems easy to use and reliable.

Thanks Fred for the rapid updates!!

Tim
[Denver, CO]

> -----Original Message-----
> From: Fred Proctor [mailto:proctor@...]
> Sent: Monday, June 14, 1999 11:29 AM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: [CAD_CAM_EDM_DRO] EMC stepper & misc fixes
>
>
> From: Fred Proctor <proctor@...>
>
> EMC users,
>
> I just put a new release of the EMC code on the FTP site. This contains
> a fix to the following error abort action and some new features. Thanks
> to Tim Goldstein for pointing these out. Details:
>
> 1. The following error abort code only looked at errors in one
> direction. This explains why the following errors only kicked in half
> the time. I wonder how this went uncorrected so long. Perhaps we were
> blaming hardware?
>
> 2. Part program verification. Forget about the "rs274ngc" command-line
> utility I mentioned. There is now a "Verify" button on the xemc GUI.
> Click this after you've opened a part program and it will run through
> checking syntax, cutter comp gouging, limit violations, etc. Let me know
> how well this works.
>
> 3. Stepper motor setup is less painful, hopefully. In your .ini file,
> set the steps-per-unit value in the [AXIS_*] INPUT_SCALE line for each
> motor, and the maximum feed rate you want in the [TRAJ] MAX_VELOCITY
> line. The cycle time for the stepper task is calculated automatically.
> Note that you still have to tune the MAX_VELOCITY so that you don't
> exceed your motor capabilities or
> run the stepper task so fast you starve everything else.
>
> See the emc/doc/RELEASE_NOTES, aka emc-14-Jun-1999.txt on the FTP site,
> for slightly more detail.
>
> Field experiences greatly appreciated. Happy Flag Day.
>
> --Fred>

Discussion Thread

Fred Proctor 1999-06-14 10:29:13 UTC EMC stepper & misc fixes Tim Goldstein 1999-06-14 22:13:10 UTC Re: EMC stepper & misc fixes Tim Goldstein 1999-06-14 23:35:50 UTC Re: EMC stepper & misc fixes Matt Shaver 1999-06-15 10:16:53 UTC Re: EMC stepper & misc fixes Jon Elson 1999-06-15 12:32:15 UTC Re: EMC stepper & misc fixes