Building a case for your stepper/servo drives
Posted by
Dan Mauch
on 2005-08-23 12:49:51 UTC
For those people that are considering building their own
case/cabinet/enclosure for their cnc controls I may have a solution for
building a custom case.
I have purchased some aluminum rails that are grooved to accept aluminum
panels from .050 to .070 thick. I can cut the rails to your specs. Then you
can build your case using 6 panels that you provide to make up the top
bottom, sides and front and back.
You can therefore easily machine flat panels to make your custom case.
Simply slide the panels into the rails and secure with screws that go into
the rails.
If interested contact me off line
Dan Mauch
Camtronics Inc
www.camtronics-cnc.com
www.seanet.com/~dmauch
low cost stepper motors , cases for gecko drives
assembled and tested systems
case/cabinet/enclosure for their cnc controls I may have a solution for
building a custom case.
I have purchased some aluminum rails that are grooved to accept aluminum
panels from .050 to .070 thick. I can cut the rails to your specs. Then you
can build your case using 6 panels that you provide to make up the top
bottom, sides and front and back.
You can therefore easily machine flat panels to make your custom case.
Simply slide the panels into the rails and secure with screws that go into
the rails.
If interested contact me off line
Dan Mauch
Camtronics Inc
www.camtronics-cnc.com
www.seanet.com/~dmauch
low cost stepper motors , cases for gecko drives
assembled and tested systems