CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] I need to cut a 20 foot sheet on a 10 foot table. How?...

Posted by wanliker@a...
on 2005-10-26 07:59:10 UTC
In a message dated 10/26/2005 6:39:08 AM Mountain Daylight Time,
apalais@... writes:

But what if I was to cut the first half of the sheet, then stop and
push the sheet up , re zero/home the cutting torch and, some how
restart the cut from where it ended.




How about two differantr cutting files, 1st half, 2nd half?


[Non-text portions of this message have been removed]

Discussion Thread

wanliker@a... 2005-10-26 07:59:10 UTC Re: [CAD_CAM_EDM_DRO] I need to cut a 20 foot sheet on a 10 foot table. How?...