RE: [CAD_CAM_EDM_DRO] Re Power Supply
Posted by
Alan Marconett
on 2005-12-16 10:36:27 UTC
HI ?,
DON'T make it complicated! Just get a transformer, cap, bridge and a few
misc. parts and build a supply. Check surplus for linear power supplies.
Run directly off the caps.
Alan KM6VV
DON'T make it complicated! Just get a transformer, cap, bridge and a few
misc. parts and build a supply. Check surplus for linear power supplies.
Run directly off the caps.
Alan KM6VV
> On Behalf Of roboticscnc
> Sent: Friday, December 16, 2005 3:36 AM
>
> Just a thought, has anyone used an old car alternator belt driven off
> the lathe spindle motor ? The cost would be virtually nothing and you
> could run 2 in series for 24 volts. The only dissadvantage I can see
> is that you couldn't test toolpaths without the spindle running. Would
> any other equipment be needed ( capacitor, etc. )
Discussion Thread
roboticscnc
2005-12-16 03:37:25 UTC
Re Power Supply
Blue
2005-12-16 10:21:36 UTC
Re: [CAD_CAM_EDM_DRO] Re Power Supply
Alan Marconett
2005-12-16 10:36:27 UTC
RE: [CAD_CAM_EDM_DRO] Re Power Supply
Dave Halliday
2005-12-16 10:42:13 UTC
RE: Power Supply (slightly off-topic) car alternators
Brian
2005-12-16 11:08:21 UTC
Re: [CAD_CAM_EDM_DRO] RE: Power Supply (slightly off-topic) car alternators
Roy J. Tellason
2005-12-16 18:38:01 UTC
Re: [CAD_CAM_EDM_DRO] Re Power Supply
Roy J. Tellason
2005-12-16 18:42:08 UTC
Re: [CAD_CAM_EDM_DRO] Re Power Supply
Mariss Freimanis
2005-12-16 19:27:23 UTC
Re: Re Power Supply
Dave Halliday
2005-12-16 20:05:57 UTC
RE: [CAD_CAM_EDM_DRO] Re: Re Power Supply