BobcadCAM- Lathe
Posted by
kiwiavi
on 2005-12-28 15:03:50 UTC
Bobcad are having a year end special. If you want lathe control, the
package currently does not support threading attached to a surface so
if you enlarge the shaft/hole you have to manuallay change the
threading G code, and it does not have a simulation mode. Tooling is
also poor.
There is due to be a new lathe module released early next year.
Cheers. Wallace
package currently does not support threading attached to a surface so
if you enlarge the shaft/hole you have to manuallay change the
threading G code, and it does not have a simulation mode. Tooling is
also poor.
There is due to be a new lathe module released early next year.
Cheers. Wallace