Re: Ounce-Inches, WAS Frozen stepper motor shaft
Posted by
Bill Yates
on 2006-01-22 08:35:08 UTC
Hello Andy,
Thanks for the help; I think that I must be losing my grip.
Kind regards,
Bill
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Andy Wander" <awander@v...>
wrote:
Thanks for the help; I think that I must be losing my grip.
Kind regards,
Bill
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Andy Wander" <awander@v...>
wrote:
>
> The torque required to provide a force of 10 lbs at a distance from the
> center of rotation of 2 ft is equal to 10lbs * 2 ft = 20 ft-lb.
>
> This same torque will provide a force of 20 lbs at a distance of 1 ft.
>
> Or 40 lbs at a distance of 1/2 ft.
>
> In each case, you multiply the force by the distance, and you get the
> torque.
>
> Note that by convention, torque is usually written as "ft-lb", while the
> identically appearing units of work are usually wriotten as lb-ft. When
> you are using other units, though, torque is usually seen written as
> "oz-in", for example. Technically, either is correct, because a time b =
> b times a.
>
>
> Andy Wander
> Verrex Corporation
>
> PS the units you referred to, lb/ft, are used, as far as I know, only in
> describing a spring constant.
>
Discussion Thread
Andy Wander
2006-01-22 04:52:55 UTC
RE: [CAD_CAM_EDM_DRO] Ounce-Inches, WAS Frozen stepper motor shaft
Chris Horne
2006-01-22 06:40:33 UTC
Re: Ounce-Inches, WAS Frozen stepper motor shaft
Andy Wander
2006-01-22 06:56:13 UTC
RE: [CAD_CAM_EDM_DRO] Re: Ounce-Inches, WAS Frozen stepper motor shaft
Bill Yates
2006-01-22 07:28:47 UTC
Re: Ounce-Inches, WAS Frozen stepper motor shaft
Andy Wander
2006-01-22 07:43:34 UTC
RE: [CAD_CAM_EDM_DRO] Re: Ounce-Inches, WAS Frozen stepper motor shaft
Bill Yates
2006-01-22 08:17:21 UTC
Re: Ounce-Inches, WAS Frozen stepper motor shaft
Andy Wander
2006-01-22 08:26:57 UTC
RE: [CAD_CAM_EDM_DRO] Re: Ounce-Inches, WAS Frozen stepper motor shaft
Bill Yates
2006-01-22 08:35:08 UTC
Re: Ounce-Inches, WAS Frozen stepper motor shaft