OT anyone with hurco experience
Posted by
jeep534
on 2006-01-29 20:17:24 UTC
This may not be the best place to ask this question but, I am looking
at starting a job shop producing machined parts. the only new machine
i have been exposed to is a hurco VM-1 does anyone have experience
with this machine and or is there another bulliten board that i could
pose this question to.......
Thanks
archie =) =) =)
at starting a job shop producing machined parts. the only new machine
i have been exposed to is a hurco VM-1 does anyone have experience
with this machine and or is there another bulliten board that i could
pose this question to.......
Thanks
archie =) =) =)