Re: [CAD_CAM_EDM_DRO] Quadrature to Step and Dir circuit
Posted by
Babar
on 2006-02-14 09:49:49 UTC
Hi All,
Have any one used the circuit Quad2StepDir.pdf ?. I am
trying to use this but am facing problem in getting
Dir output , at the step output I am getting X 4
output , however at the Dir output there is again
pulses not simply high or low level depending upon the
direction of Encoder movement. Do I need some
additional circuit to convert these pulses to high or
low signal for Dir identification?
Thanks
Babar
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
Have any one used the circuit Quad2StepDir.pdf ?. I am
trying to use this but am facing problem in getting
Dir output , at the step output I am getting X 4
output , however at the Dir output there is again
pulses not simply high or low level depending upon the
direction of Encoder movement. Do I need some
additional circuit to convert these pulses to high or
low signal for Dir identification?
Thanks
Babar
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
Discussion Thread
macglobalus
2006-02-13 21:43:58 UTC
nice site
BobWarfield
2006-02-14 08:19:04 UTC
Re: nice site
Babar
2006-02-14 09:49:49 UTC
Re: [CAD_CAM_EDM_DRO] Quadrature to Step and Dir circuit