No need to learn CAD
Posted by
wanliker@a...
on 2006-02-21 10:23:53 UTC
In a message dated 2/21/2006 11:16:59 AM Mountain Standard Time,
thinkcnc@... writes:
Hi to all,
Here's a easy way to make a Lathe or Mill or Drill gcode file and if
you want to use CAD you can. Make a finish profile for your lathe then
use Mach 3 Turn to machine it.
There are also PDF's to look at:
http://STcnc.tripod.com/dxftools
Thinkcnc
Bob
I did not see a demo, so that we could try it before buying, Is this an
oversight? I think most members would like to try before they buy. Maybe make
a demo with only a limited numbers of GCode lines allowed, or a number on
conversions, with a password to eliminate that restriction after purchasing??
bill
List Mom
[Non-text portions of this message have been removed]
thinkcnc@... writes:
Hi to all,
Here's a easy way to make a Lathe or Mill or Drill gcode file and if
you want to use CAD you can. Make a finish profile for your lathe then
use Mach 3 Turn to machine it.
There are also PDF's to look at:
http://STcnc.tripod.com/dxftools
Thinkcnc
Bob
I did not see a demo, so that we could try it before buying, Is this an
oversight? I think most members would like to try before they buy. Maybe make
a demo with only a limited numbers of GCode lines allowed, or a number on
conversions, with a password to eliminate that restriction after purchasing??
bill
List Mom
[Non-text portions of this message have been removed]
Discussion Thread
stcnc2000
2006-02-21 10:15:43 UTC
No need to learn CAD
wanliker@a...
2006-02-21 10:23:18 UTC
Re: [CAD_CAM_EDM_DRO] No need to learn CAD
wanliker@a...
2006-02-21 10:23:53 UTC
No need to learn CAD