RE: [CAD_CAM_EDM_DRO] Re: Vector CAD

Hi Bill,

You need to look under NC for the function. It has a default depth of cut.
I back-plotted from your part contour and was able to generate tool paths on
it. It's not going to follow the "fins" very well at all (at least for the
roughing-finishing function I selected). You also need to have the contour
selected, just as if you were making an offset (for mill).

Alan KM6VV

>
> Are you selecting roughing-finish under lathe? This will DRAW the passes
> on
> your drawing, which you then select and send to the NC module.
>
>
>
>
> Yes I selected Lathe, and a tool that would work also with angles that
> would
> work, but no passes shown, nothing about tool depth of cut.
> bill
>