CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] FAQ - Component Selection

Posted by wanliker@a...
on 2006-03-05 16:17:16 UTC
In a message dated 3/5/2006 4:56:57 PM Mountain Standard Time,
tsaldoff@... writes:

Is there a FAQ link?

I'm interested in getting the basic engineering design information for
component selection. Selection of servo motors, ballscrews, slide
components, encoders, etc.




At the bottom of every message, look under Addresses.
bill


[Non-text portions of this message have been removed]

Discussion Thread

lvrofbats 2006-03-05 15:56:21 UTC FAQ - Component Selection wanliker@a... 2006-03-05 16:17:16 UTC Re: [CAD_CAM_EDM_DRO] FAQ - Component Selection