Re: [CAD_CAM_EDM_DRO] Maxnc -kellyware
Posted by
Derek B.
on 2000-07-04 19:09:13 UTC
mike,
I don't know if you tried to adjust the speed in the table setup adjust
feed rate ___in/min.
Try that if you didn't.
Derek B.
Mike Rainone wrote:
I don't know if you tried to adjust the speed in the table setup adjust
feed rate ___in/min.
Try that if you didn't.
Derek B.
Mike Rainone wrote:
>
> I have now tested Kellyware and CNCpro. The Kellyware is truly idiot proof. Sets up nicely, easy to understand, runs the Camtronic's
> stepper board. Let me say that again, it runs the Camtronic's stepper board s l o o o o w w l l y y y
> y. I used my Compaq PII366 laptop, 128mg, win98 so I think that this limit is a function of win98, but I am not sure. Comments,
> suggestions?
>