CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question

Posted by ptengin@a...
on 2000-07-05 15:43:52 UTC
In a message dated 07/05/2000 11:17:52 AM Hawaiian Standard Time,
arraycom@... writes:

<< Actually the term I need was lead. A .2 lead will give .2" travel with one
turn?
>>

Yes, pitch and lead are not the same. A 2 start thread could have a pitch of
0.05 but a lead of 0.1. A single start .2" lead screw will travel .2" with
one turn.

Discussion Thread

Jon Elson 2000-07-05 11:33:45 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question Ron Ginger 2000-07-05 11:38:09 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question Ejay Hire 2000-07-05 13:43:22 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question Barry 2000-07-05 14:04:46 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question Jon Elson 2000-07-05 15:02:35 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question ptengin@a... 2000-07-05 15:39:43 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question ptengin@a... 2000-07-05 15:43:52 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question JanRwl@A... 2000-07-05 20:40:41 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question Ejay Hire 2000-07-06 06:53:35 UTC Re: [CAD_CAM_EDM_DRO] Ballscrew stupid Question