CAD CAM EDM DRO - Yahoo Group Archive

Bridgeport Torq-Cut 22 Question

Posted by lvrofbats
on 2006-05-15 13:39:27 UTC
We have the subject machine at work. I'm wondering if any group
members are familiar with the machine and could answer a question or
two?

I'm looking at a potential set-up which will require the opening and
closing of several sets of holding clamps. I'd like to do this with
M codes that will open and close the hydraulic clamps on command.

I'd also like to provide for both a programmable time delay, another
M code, and some sort of feedback signal to insure the clamps have
cleared before the program can continue its cutting.

Thanks...


Tom

Discussion Thread

lvrofbats 2006-05-15 13:39:27 UTC Bridgeport Torq-Cut 22 Question wthomas@g... 2006-05-15 22:31:01 UTC W.E.T. [CAD_CAM_EDM_DRO] Bridgeport Torq-Cut 22 Question