CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] student project

Posted by Bob Campbell
on 2000-07-07 19:06:18 UTC
Peter,

If we knew where she lived , then someone near her should be able to give
her some help.

Bob

----- Original Message -----
From: Peter Chen <cadcamcenter@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Friday, July 07, 2000 7:40 PM
Subject: [CAD_CAM_EDM_DRO] student project


> A student hopes to purchase some motion control items
> such as lead/ball screws, motors servo or otherwise,
> and fabricate a xy-table to connect to a computer for
> control of a Dremel handtool for engraving and
> simulation for milling, She has used the Flashcutcnc
> software and is familiar with Autocad. She has not
> really tried other softwares such as Bobcad as it seem
> more complicated (new learner) but find Flashcut easy
> to use with dxf file import, and hopes to fabricate
> the x-y table and connect it to a software such as
> Flashcutcnc (the xy dimensions for the Sherline mill
> is too small). Anybody can offer comments,
> suggestions, useful lead, etc? Thanks.
>
> ____________________________________________________________
> Do You Yahoo!?
> Get your free @... address at http://mail.yahoo.co.uk
> or your free @... address at http://mail.yahoo.ie
>
> ------------------------------------------------------------------------
> Find long lost high school friends:
> http://click.egroups.com/1/5535/4/_/423600/_/963016824/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

Discussion Thread

Bob Campbell 2000-07-07 19:06:18 UTC Re: [CAD_CAM_EDM_DRO] student project johndroc@a... 2000-07-07 19:34:53 UTC Re: [CAD_CAM_EDM_DRO] student project