Re: [CAD_CAM_EDM_DRO] Re: steppers or servo?

----- Original Message -----
From: Mariss Freimanis <geckohall@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, July 10, 2000 12:06 PM
Subject: [CAD_CAM_EDM_DRO] Re: steppers or servo?


>
> I'm confessing some ignorance here. Who makes this motor? If you
> would let me know I'll get some info on it.
>
> Mariss
>
> --- In CAD_CAM_EDM_DRO@egroups.com, "Bob Campbell" <bob@c...> wrote:
> > Mariss,
> >
> > Thanks for the information.
> >
> > Have you ever looked at the new 3 phase stepper motors.
> >
> > Bob Campbell
>
>
>
> ------------------------------------------------------------------------
> Special Offer-Earn 300 Points from MyPoints.com for trying @Backup
> Get automatic protection and access to your important computer files.
> Install today:
> http://click.egroups.com/1/6347/4/_/423600/_/963248792/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager