Re: [CAD_CAM_EDM_DRO] Re: LS-120 super disk
Posted by
Bob Campbell
on 2000-07-11 18:31:57 UTC
Fred,
Thanks for the suggestion. I will try it. My Model Mill program can make
large files due to the way that it does the machining in a raster format.
If you do a 95% step over with a 1/8 inch bit the files can get large.
Bob Campbell
Thanks for the suggestion. I will try it. My Model Mill program can make
large files due to the way that it does the machining in a raster format.
If you do a 95% step over with a 1/8 inch bit the files can get large.
Bob Campbell
----- Original Message -----
From: Fred Smith <imserv@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Tuesday, July 11, 2000 6:53 PM
Subject: [CAD_CAM_EDM_DRO] Re: LS-120 super disk
>
>
> >I need something to transfer data from my office (cad/cam) system to my
shop
> >DOS systems that drive my cnc routers. When using Model Mill my files
> >sometimes exceed 1.4 meg. When I get my new shop built, I may use
FlashCut
> >and network all my computer together.
>
> Bob, I would suggest you look into using a .zip file compression routine.
G-code is a pig,
> when it comes to storage efficiency. (as are most ascii cad file formats,
like DXF & IGES)
> The files will probably compact to about 10 percent or less if zipped,
and that means that
> you can put about 10-14Meg files on a single floppy. I know it's not as
fun as playing with
> hardware, but it is probably more practical, and just about as effective.
>
>
> Best Regards, Fred Smith- IMService
> Listserve Special discounts and offers are at:
http://209.69.202.197/cadcamedmdro.html
>
> imserv@... Voice:248-486-3600 or 800-386-1670 Fax: 248-486-3698
>
>
> ------------------------------------------------------------------------
> BTW: Did you buy that new car yet?
> If not, check this site out.
> They're called CarsDirect.com and it's a pretty sweet way to buy a car.
> http://click.egroups.com/1/6847/4/_/423600/_/963359370/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager