Re: [CAD_CAM_EDM_DRO] Which cad bob or turbo?

In a message dated 8/5/2006 1:15:47 A.M. Eastern Daylight Time,
shawncd@... writes:

I'm trying to decide between cad cam programs and I would like to everyones
thoughts. I choosing between Turbocad and Bobcad.
Which one is the better?
Thanks



If all you plan to do is draw 2D or 3D drawings, for the money DesignCad w
ould be a good choice. It is distributed by IMSI (TurboCad) but is a lot less
expensive and works great. If you are looking for a higher level CAD for
just drawings, the TurboCad would be a good choice. BobCad is not all that easy
to use but it does allow CAM as well. So you can do the NC code with the
BobCad. However, BobCad would not be my first choice unless it was almost free.

Randy


[Non-text portions of this message have been removed]