RE: [CAD_CAM_EDM_DRO] Re: Bridgeport Series I for sale, ZIP 93117
Posted by
Chuck Merja
on 2006-08-28 07:46:15 UTC
I had found a Birdgprot II with low voltage board problems and was going to
ask what it would take money and time wise to put in a new set of controls.
This post prompts me to finally ask - and also ask what system would you
guys install?
Chuck Merja
All you read are posts about people whinging about "I can't find a mill etc.
" and when one pops up they convieniantly ignore it then post later "I wish
I had known"
Read it again.
Bridgy with all the guts ripped out saving you the hassle.
Chrome ways, ballscrews etc etc.
Then throw in a 4th axis and tooling and at $400 you have stolen it.
[Non-text portions of this message have been removed]
ask what it would take money and time wise to put in a new set of controls.
This post prompts me to finally ask - and also ask what system would you
guys install?
Chuck Merja
> Elliot,I'm suprised it hasn't gone already.
> I'm within easy hauling range of Goleta, but I have to wait a few
> weeks until I save up enough money for a funeral. My wife would kill
> me if I bought another mill.
>
> Marv Frankel
> Los Angeles
All you read are posts about people whinging about "I can't find a mill etc.
" and when one pops up they convieniantly ignore it then post later "I wish
I had known"
Read it again.
Bridgy with all the guts ripped out saving you the hassle.
Chrome ways, ballscrews etc etc.
Then throw in a 4th axis and tooling and at $400 you have stolen it.
[Non-text portions of this message have been removed]
Discussion Thread
John Stevenson
2006-08-28 00:25:11 UTC
Re: Bridgeport Series I for sale, ZIP 93117
Chuck Merja
2006-08-28 07:46:15 UTC
RE: [CAD_CAM_EDM_DRO] Re: Bridgeport Series I for sale, ZIP 93117