CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] I have a problem with my computer freezing up.

Posted by David Speck
on 2006-09-07 15:23:52 UTC
Peter, Harko,

In Safe Mode, also disable System Restore service. Some nasty viruses
use it to reinstall themselves after you clean them out. After you get
the machine running properly, you can re-enable it.

Also, as mentioned, in MSCONFIG, in the right most "Startup" tab,
uncheck any program names you don't recognize, especially any blank
lines, or programs with cryptic names like Cx8Qgx93. Many are viruses.

Uncheck programs like Real Payer, QTTask, Winamp, or anything else not
immediately related to the CNC program. After you reboot, things should
run much faster.

Dave

Harko Schwartz wrote:
> goto start program run and enter msconfig and then pick options that will
> remove parts of programs that would normally run on startup.
>
>
> Harko
>

Discussion Thread

apples0_17 2006-09-07 00:26:13 UTC I have a problem with my computer freezing up. Harko Schwartz 2006-09-07 03:53:39 UTC Re: [CAD_CAM_EDM_DRO] I have a problem with my computer freezing up. kz1927 2006-09-07 05:23:38 UTC Re: I have a problem with my computer freezing up. tony wong 2006-09-07 06:57:03 UTC Re: [CAD_CAM_EDM_DRO] Re: I have a problem with my computer freezing up. Apalais 2006-09-07 12:06:05 UTC Re: [CAD_CAM_EDM_DRO] I have a problem with my computer freezing up. Apalais 2006-09-07 12:15:56 UTC Re: [CAD_CAM_EDM_DRO] Re: I have a problem with my computer freezing up. Apalais 2006-09-07 12:35:57 UTC Re: [CAD_CAM_EDM_DRO] Re: I have a problem with my computer freezing up. David Speck 2006-09-07 15:23:52 UTC Re: [CAD_CAM_EDM_DRO] I have a problem with my computer freezing up. Bill Newell 2006-09-07 15:43:51 UTC RE: [CAD_CAM_EDM_DRO] Re: I have a problem with my computer freezing up. Apalais 2006-09-10 16:40:26 UTC Re: [CAD_CAM_EDM_DRO] Re: I have a problem with my computer freezing up.