Re: starting from scratch
Posted by
TADGUNINC@x...
on 1999-06-16 06:45:02 UTC
OK, let the adventures begin!
Apparently there are a lot of people just reading "lurkers" on this list with
as little background and knowledge of EMC, Linux, and CNC as myself. Maybe
all the help I have received, and hope to continue receiving, will get more
people involved!
I'm am going to be going through a complete conversion and set up of a
cnc mill and Linux on a new computer. So to start with the basics My first
purchase is going to be the Linux OS. The version they have at Barnes and
Noble is 5.2 is this the version I'm looking for?
Have seen talk on the list about 6.0 and haven't seen it anywhere, not to
mention it sounds like there are some unresolved problems for the EMC
application.
Thanx to Don, Ted, Matt, and everyone else that has been so patient and
helpful thus far.
Tracey DeChambeau
Tadguninc@...
Apparently there are a lot of people just reading "lurkers" on this list with
as little background and knowledge of EMC, Linux, and CNC as myself. Maybe
all the help I have received, and hope to continue receiving, will get more
people involved!
I'm am going to be going through a complete conversion and set up of a
cnc mill and Linux on a new computer. So to start with the basics My first
purchase is going to be the Linux OS. The version they have at Barnes and
Noble is 5.2 is this the version I'm looking for?
Have seen talk on the list about 6.0 and haven't seen it anywhere, not to
mention it sounds like there are some unresolved problems for the EMC
application.
Thanx to Don, Ted, Matt, and everyone else that has been so patient and
helpful thus far.
Tracey DeChambeau
Tadguninc@...
Discussion Thread
TADGUNINC@x...
1999-06-16 06:45:02 UTC
Re: starting from scratch
Matt Shaver
1999-06-16 12:55:19 UTC
Re: starting from scratch
Jon Anderson
1999-06-16 13:50:02 UTC
Re: starting from scratch
MIADsgns@x...
1999-06-16 14:35:53 UTC
Re: starting from scratch
Jon Anderson
1999-06-16 16:37:47 UTC
Re: starting from scratch