Seeking CNC shop for small 2D job in brass
Posted by
lostfrom68jay
on 2007-01-28 17:10:54 UTC
I need someone to cut a simple Y-symetric key shape from
1/2"x3/16" 360 brass bar. The large end then has to have an
angled surface cut, bored, and threaded at the same angle. No finishing
or deburring of any kind will be needed. I will want about 80 pieces,
which would require 12' of stock. View a drawing at this link: Key
<http://pg.photos.yahoo.com/ph/lostfrom68jay/detail?.dir=/3bd2re2&.dnm=c\
474re2.jpg&.src=ph>
I can send .dxfs, Bobcad .cad or .igs files.
I hope It's OK to post a message like this here.
= = = = =
Moderators note : Please respond off-list.
Thanks
1/2"x3/16" 360 brass bar. The large end then has to have an
angled surface cut, bored, and threaded at the same angle. No finishing
or deburring of any kind will be needed. I will want about 80 pieces,
which would require 12' of stock. View a drawing at this link: Key
<http://pg.photos.yahoo.com/ph/lostfrom68jay/detail?.dir=/3bd2re2&.dnm=c\
474re2.jpg&.src=ph>
I can send .dxfs, Bobcad .cad or .igs files.
I hope It's OK to post a message like this here.
= = = = =
Moderators note : Please respond off-list.
Thanks