Series I BP project for sale (previously a BOSS 5)

I know this group is probably not the appropriate place to sell
things, but I wanted you guys to have the first shot. I need
something that works now, and I just don't have time to play with it
anymore. The BOSS5 control is gone. I ran it with gecko201's and
deskcnc with 2nd gen controller board. The original steppers were
losing steps in large (65000 line) programs. I started upgrading to
servos, but just don't have time to finish. The ways are a little
worn, and the lube system needs cleaned out. The spindle taper is
worn and shows runout on part of the toolholders. I replaced the
spindle bearings with Fafnir precision bearings but think the taper
may need redone. Anyway heres what I got:
one machine, no controller
-4 gecko201's stepper drivers
-3 rutexR910 servo drivers
-3 centroid 29 in-lb servo motors
http://ajaxcnc.com/cnc_components.htm)
-5 original boss5 stepper motors one with an extra ballscrew.
Motors all seem to run fine, but they lose steps in large programs,
but that could have been my acceleration curves in the software.
-roughly 30 toolholders kwik switch II, most are worn on the ear
part, don't know if that can be fixed, a couple are new, I'll get a
better count if somebody is interested
deskcnc software and 2nd gen controller (if the liscence is
transferable

I'd be glad to sell all of this together, or seperately.
Sorry if this is the wrong place for this, but I wanted to make sure
it went to somebody who knew what to do with it.

Thanks
Nate
rocketscientistnate@...