Re: Mach3 Wizards

>
> I'm looking for some help with the Mach3 Wizards so if you consider yourself a "Mach3 Wizard" no pun intended, could you please point me in the right direction for some documentation on the individual wizards, or maybe some tips. The problem is that I don't know enough about all of the settings such as "plunge depth" and other terms. I have mastered drawing a circle with a pen with the "circular pocket" wizard, so that's something! I was trying to draw a circle this evening with the "Shapes" wizard but the bit kept wandering off - I'm not sure where to start the tool (where to put zero x and zero y) - in the center of the circle, or some point off the center - see how much I DON'T know! Thanks for any help you have to offer. An offline email would be fine if this is too elementary for the rest of the group.
>
> Thanks,
>
> Laughlin
> Omaha, Nebraska
>

As others have suggested look at the mach1mach2cnc group on yahoo, but
it might be better to go to the www.machsupport.com forum. There is one
specifically for the wizards, see
http://www.machsupport.com/forum/index.php?board=3.0

I am now doing the support and development for the newfangled set of
wizards. One of the changes I have started is to add help screens to
many of the wizards. Ive also added a Power Feed wizard that simply
works like a mill power feed, and a new teach wizard, I think I'm going
to name 'CopyCat' All of these are posted on the forum.

ron ginger