CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] spindle start and stop

Posted by Doug Harrison
on 2000-07-23 09:51:28 UTC
> > Hi,
> > I wish to start and stop the spindle on the machine I am building
> > using M codes (M3, M5 ?) What would be the proceedure? I can remember
> > reading somehere that a relay connected to a pin on the port will do
> > the trick? The drive motor is a 3.3 amp.
> > Thanks in advance, Terry
>
Hello Terry;

I selected Crydom solid state relays for the wonderboard project. They are
available from DigiKey in a variety of configurations and capacity.

The one you need is Crydom # CX24005 (DigiKey # C-1063-ND) which sells for
$9.02. This unit requires 3-15 VDC to fire and will handle 280 VAC at up to
5A.

I have assumed you require AC switching. If not, DC configurations are also
available.

Doug

Discussion Thread

Darrell 2000-07-22 18:30:33 UTC Re: [CAD_CAM_EDM_DRO] spindle start and stop James Owens 2000-07-23 05:37:03 UTC Re: [CAD_CAM_EDM_DRO] spindle start and stop Terry Ackland 2000-07-23 08:42:26 UTC Re: spindle start and stop Doug Harrison 2000-07-23 09:51:28 UTC Re: [CAD_CAM_EDM_DRO] spindle start and stop Darrell 2000-07-23 13:15:15 UTC Re: [CAD_CAM_EDM_DRO] spindle start and stop wanliker@a... 2000-07-23 14:33:48 UTC Re: [CAD_CAM_EDM_DRO] spindle start and stop Terry Ackland 2000-07-23 14:45:45 UTC Re: spindle start and stop ptengin@a... 2000-07-24 02:59:38 UTC Re: [CAD_CAM_EDM_DRO] spindle start and stop