Re: [CAD_CAM_EDM_DRO] Re: component data sheets

Gary wrote:

> Thanks Tim, that was exactly what I needed. Thanks again!--- In
> CAD_CAM_EDM_DRO@egroups.com, "Tim Goldstein" <timg@k...> wrote:
> > Try:
> > http://www.allegromicro.com/datafile/archive/2993.pdf
> >
> > Tim
> > [Denver, CO]
> >
> > > I am building the interface cards from boondog automation. I
> hope
> to
> > > apply some of the results to my DRO+ (Tom Kulaga's) to run the
> EDM
> > > outlined in Home Shop Machinist. Does anyone have a source of
> data
> > > sheets for IC's? I want to upgrade the Boondog PWM card to the
> 2998
> > > IC bridge and can't find the data sheet for Allegro's UDN2993.
> Any
> > > help or direction would be appreciated.
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

The data sheets for the dro should be linked from Tom's DRO page or just go to http://usdigital/com.

Allegro has a *.pdf data sheet for the 2993 on their web page. Good luck.

dave