Re: typical servo speeds
Posted by
Graham Stabler
on 2007-07-18 01:22:31 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "vrsculptor" <vrsculptor@...>
wrote:
flying version).
Graham
wrote:
>Its for an aerodynamic test rig not a flying version (my job is the
> Graham,
> Interesting question. If you are talking about wings then weight is
> probably an issue. For slower wings I would look at muscle wires. For
> high speed flapping of small wings I would consider piezo motors. With
> either choice you can easily do multiple degrees of freedom with fully
> proportional control without gearboxes. You can do positional feedback
> using fiber optic transducers. The amount of light passed through a
> fiber is proportional to the bend. With a few fibers and an ARM class
> micro you should be able to do closed loop control.
>
> Roger
>
flying version).
Graham
Discussion Thread
Graham Stabler
2007-07-17 10:59:31 UTC
typical servo speeds
David G. LeVine
2007-07-17 12:25:26 UTC
Re: [CAD_CAM_EDM_DRO] typical servo speeds
vrsculptor
2007-07-17 16:37:19 UTC
Re: typical servo speeds
Jon Elson
2007-07-17 18:20:37 UTC
Re: [CAD_CAM_EDM_DRO] typical servo speeds
Jon Elson
2007-07-17 21:48:23 UTC
Re: [CAD_CAM_EDM_DRO] typical servo speeds
Graham Stabler
2007-07-18 01:22:31 UTC
Re: typical servo speeds
Graham Stabler
2007-07-18 01:29:26 UTC
Re: typical servo speeds
optics22000
2007-07-18 06:28:04 UTC
Re: typical servo speeds
Ron Kline
2007-07-18 06:36:11 UTC
Re: [CAD_CAM_EDM_DRO] Re: typical servo speeds
Graham Stabler
2007-07-18 06:55:15 UTC
Re: typical servo speeds
Jon Elson
2007-07-18 10:05:57 UTC
Re: [CAD_CAM_EDM_DRO] Re: typical servo speeds
Jon Elson
2007-07-18 10:12:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: typical servo speeds
Graham Stabler
2007-07-18 15:57:16 UTC
Re: typical servo speeds
vrsculptor
2007-07-18 17:05:23 UTC
Re: typical servo speeds
R Wink
2007-07-18 17:06:00 UTC
RE: [CAD_CAM_EDM_DRO] Re: typical servo speeds