Re: [CAD_CAM_EDM_DRO] CNCing a Phase 2 Rotary Table
Posted by
Dan Mauch
on 2007-08-21 09:24:25 UTC
I think I found the problem. There is a threaded pin in the bottom of the rotary table retained by a set screw. I got the set screw out but the threaded pin wouldn't turn using a 2.5mm allen wrench. I tried various other sizes and they all slip.
Hmmm. I hope I don't have to drill it out.
Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch
Hmmm. I hope I don't have to drill it out.
Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch
----- Original Message -----
From: Dan Mauch
To: CAD_CAM_EDM_DRO@yahoogroups.com
Sent: Tuesday, August 21, 2007 7:36 AM
Subject: [CAD_CAM_EDM_DRO] CNCing a Phase 2 Rotary Table
I am adding a stepper motor to drive a 8" Phase 2 rotary table. I ran into a problem in that the eccentric sleeve does not rotate quite far enough to eliminate the backlash between the worm and worm wheel. The phase 2 6 inch, 8 inch and 10 inch tables all use the same eccentric sleeves.
I have concluded that the Phase 2 parts and instruction manual exploded view is drawn incorrectly based on how the parts have to be taken off. I have tried to gently pull the pc 37 excentric sleeve from the housing but don't want to use force. It wouldn't come out.
I suspect something is holding it in place but don't see and retaining or locking screws holding the eccentric sleeve in place.
Has anyone ever removed their pc 37 eccentric sleeve? If so how?
Dan Mauch
economical 3D scanner software and kits
low cost stepper and servo motors.
cases for Gecko drives
kits and assembled 3-4 axis drives
www.camtronics-cnc.com
www.seanet.com/~dmauch
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]
Discussion Thread
Dan Mauch
2007-08-21 07:40:54 UTC
CNCing a Phase 2 Rotary Table
Dan Mauch
2007-08-21 09:24:25 UTC
Re: [CAD_CAM_EDM_DRO] CNCing a Phase 2 Rotary Table