CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: [sherline] Help

Posted by bfp
on 2000-08-01 23:00:39 UTC
Marv Klotz's website has some utilitys that may help
http://www.geocities.com/CapeCanaveral/Hall/4425/
page down to find the description for the rotary table utility
http://www.geocities.com/CapeCanaveral/Hall/4425/rotary.zip

Brian


"Wm. Dubin" wrote:
>
> I want to make pentagrame shaped nuts for a sculpture I am getting ready
to
> start. These will be in sizes 1-72, 2-56 and 4-40.......... so the steel
rod
> will not be hard to find.
>
> I have a rotary table and tail-stock, so it's simply a question of
milling
> the rod with 5 flats............... however, when I do the math, I get
the
> results of turning the table's handwheel 14.4 turns per flat.
>
> Neither my math abilities, nor my rotary table knowledge are good enough
to
> cope with .4 on the handwheel...
>
> Has anyone a solution that can be simply applied?
>
> Thanks in advance,
>
> Wm. Dubin

Discussion Thread

bfp 2000-08-01 23:00:39 UTC Re: [CAD_CAM_EDM_DRO] Re: [sherline] Help