CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Newbie questions???????

Posted by Steve Blackmore
on 2008-01-07 02:14:33 UTC
On Sun, 06 Jan 2008 20:54:05 -0500, you wrote:

>Well, there is EMC2, which handles automatic toolchangers (and manual
>tool changes) and tool compensation quite nicely :)

Yea - but it's Linux, I seem to have no luck getting it to run and I'm
too old to start playing about learning a whole new operating system and
becoming a programmer to configure it via Hal files.

Steve Blackmore
--

Discussion Thread

Jack Mc Kie 2008-01-03 07:46:53 UTC Newbie questions??????? Michael Fagan 2008-01-03 10:08:00 UTC Re: [CAD_CAM_EDM_DRO] Newbie questions??????? Dan Mauch 2008-01-03 11:09:35 UTC Re: [CAD_CAM_EDM_DRO] Newbie questions??????? Jack McKie 2008-01-03 11:10:21 UTC Re: [CAD_CAM_EDM_DRO] Newbie questions??????? Harko Schwartz 2008-01-03 17:38:02 UTC Re: [CAD_CAM_EDM_DRO] Newbie questions??????? Jack McKie 2008-01-03 17:38:02 UTC Re: [CAD_CAM_EDM_DRO] Newbie questions??????? Fred Smith 2008-01-04 04:10:54 UTC Re: Newbie questions??????? Jack McKie 2008-01-04 13:54:16 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Will 2008-01-05 12:27:36 UTC Re: Newbie questions??????? Dan Mauch 2008-01-05 17:28:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Will 2008-01-05 19:08:55 UTC Re: Newbie questions??????? Steve Blackmore 2008-01-06 01:14:30 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Will 2008-01-06 08:40:16 UTC Re: Newbie questions??????? Dan Mauch 2008-01-06 10:14:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Steve Blackmore 2008-01-06 13:05:09 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Stephen Wille Padnos 2008-01-06 13:14:10 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Will 2008-01-06 13:59:02 UTC Re: Newbie questions??????? Steve Blackmore 2008-01-06 17:19:21 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Stephen Wille Padnos 2008-01-06 17:53:53 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions??????? Steve Blackmore 2008-01-07 02:14:33 UTC Re: [CAD_CAM_EDM_DRO] Re: Newbie questions???????