Shoptask Eldorado Bridgemill CNC Retrofit
Posted by
Bill Anderson
on 2008-12-13 16:26:41 UTC
I have just purchased a used bridgemill with variable speed 1.5hp dc
motors. I am enrolled in an intro machine tool course and plan to
eventually upgrade the shoptask. In the meantime I am planning to
install the Shoptask Pro-line DRO. I was hoping someone on the list has
done this and provide some guidance since the bridgemill does not have
pre-drilled holes and the DRO does not have any device specific
installation instructions or mounting hardware. Any help or advise
would be appreciated.
thanks
bill a.
motors. I am enrolled in an intro machine tool course and plan to
eventually upgrade the shoptask. In the meantime I am planning to
install the Shoptask Pro-line DRO. I was hoping someone on the list has
done this and provide some guidance since the bridgemill does not have
pre-drilled holes and the DRO does not have any device specific
installation instructions or mounting hardware. Any help or advise
would be appreciated.
thanks
bill a.