FANUC WIRE EDM CUT W1
Posted by
lonoski2
on 2009-01-26 10:11:06 UTC
Hi
I have a FANUC CUT W1 wire edm, but I did not receive the
"CUTTING CONDITION CHART" that is mentioned in the
operator's manual. There should be a page A and page B on these chart.
Can anybody send me a copy of the chart.
Thank You
I have a FANUC CUT W1 wire edm, but I did not receive the
"CUTTING CONDITION CHART" that is mentioned in the
operator's manual. There should be a page A and page B on these chart.
Can anybody send me a copy of the chart.
Thank You