Looking for parts for a Mill-Drill (You may have them if you CNCed your mill)

I need a few parts for a Mill-Drill I am rebuilding. It's a Rong-Fu RF30.

I need:

2 HP 1725RPM 1Phase Motor (my motor went out on me)

Table Handles (The whole handle, or just the black handle ends)

Table Handle Clutch Dials (The .001 silver dials)

Depth Red Arrow Indicator

Depth Adjustment Screw (long black screw that the indicator moves on)

Depth Adjustment Scale (Inches/MM Scale)

Table Lock Down Handles

Warning Label that screws into the front face (above the depth adjustment scale)

A DRO set (would like to find a Anilam Wizard 411) or any set that that is good. 2 or 3 axis is fine.

I'm refurbishing a mill/drill that was left for dead in a corner of a bowling center. I'm looking to give it new life and a new home at my establishment.