CAD CAM EDM DRO - Yahoo Group Archive

Re: How do you connect AC servo motor up

Posted by cnc_4_me
on 2010-06-17 14:44:39 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Jon Elson <elson@...> wrote:
>
> cnc_4_me wrote:
> > Do AC servo motors all have same pinout on them for wiring as in universial connector. If not, how do you figure out wiring for a surplus motor.
> >
> No, it is a LOT more complicated. Usually the motors are 3-phase,
> permanent magnet, but there can be other types.
> It is common to have Hall sensors for commutation, but not all motors
> have these sensors. There are several schemes
> for orienting these sensors to the motor poles. The motors typically
> have 8 poles, but some may have other pole counts.
> Encoders have all sorts of combinations available, some have the
> commutation tracks and some don't, etc. If the encoder has
> the commutation signals, then the alignment of the encoder to the
> motor's poles is critical. Also, some motors, such as Yaskawa,
> Panasonic and Fanuc often have something proprietary about the
> commutation or encoder signals.
>
> So, not only is the connector totally NOT standard, the signals
> themselves vary quite a bit.
>
> Jon
>


You sure know how to depress a man. So much for undocumented Ebay motors.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=220385535101&ssPageName=STRK:MEWAX:IT

These are the ones i wanted to get. But i can not find word one on them.

cnc4me

Discussion Thread

cnc_4_me 2010-06-16 13:23:38 UTC How do you connect AC servo motor up Michael Fagan 2010-06-16 13:42:27 UTC Re: [CAD_CAM_EDM_DRO] How do you connect AC servo motor up Thomas Powderly 2010-06-16 17:11:57 UTC Re: [CAD_CAM_EDM_DRO] How do you connect AC servo motor up RANDY ABERNATHY 2010-06-16 17:12:17 UTC Re: [CAD_CAM_EDM_DRO] How do you connect AC servo motor up Jon Elson 2010-06-16 19:14:28 UTC Re: [CAD_CAM_EDM_DRO] How do you connect AC servo motor up cnc_4_me 2010-06-17 14:44:39 UTC Re: How do you connect AC servo motor up Michael Fagan 2010-06-17 14:47:15 UTC Re: [CAD_CAM_EDM_DRO] Re: How do you connect AC servo motor up Jon Elson 2010-06-17 19:18:37 UTC Re: [CAD_CAM_EDM_DRO] Re: How do you connect AC servo motor up Mark Thomas 2010-06-19 20:51:30 UTC truetype-tracer utility program Mark Thomas 2010-06-25 01:48:40 UTC Re: [CAD_CAM_EDM_DRO] truetype-tracer utility program (now with g-code) output.