PMDX-111, new Parallel Port Monitor board

************************************************
PMDX will be exhibiting The PMDX-111 and the new
PMDX-133 motherboard for Geckos at the Cabin Fever
show on January 15th and 16th in York, PA. Drop
by and see us there.
************************************************

PMDX is now offering a new board to provide
hardware monitoring of parallel port signals.

It provides individual LEDs to monitor all 17
active parallel port signals.

All signals buffered to minimize loading on signals.

Equipped with one DB-25 female, one DB-25 male, and
a ribbon cable interface.

All signals connected in parallel on all connectors,
thus allowing signals to pass through the board for
any cable combination.

Provides one selectable edge/pulse detector that can
monitor any one of the 17 signals for transitions.

Also has a dedicated Pin 17 pulse detector for a
charge pump signal monitor.

Each signal has a 10K ohm pull down resistor to assure
that open signals present as a logic "Low".

Can be powered by AC or DC power from 6 to 12 volts.

Can also be powered from a USB port.

Excellent tool for testing, training, and experimentation.

The PMDX-111 is available now at $39.00 each. See:

http://www.pmdx.com/TestDevTools

Regards,
Steve Stallings
www.PMDX.com