Re: [CAD_CAM_EDM_DRO] Goldmine servos
Posted by
djr@n...
on 2000-08-15 09:54:31 UTC
FYI
I found an easy way to remove the encoder disk!
I used small wire clippers to snip off the individual clips of the retaining washer, removed it and then I soaked the end of the
motor shaft with the encoder disk attached in acetone for about 10 minutes. You can then lift the encoder disk off the shaft very
easily with a couple of razor blades, one on each side between the encoder disk and the thick washer attached to the motor shaft.
The acetone does a great job a loosening the glue and does not seem to hurt the encoder disk itself.
- Dan
marble_h@... wrote:
Daniel Rubin, (614) 457-5919 - Web Site Hosting
President, Newcoast Communications, Inc. - Email Services
- Intranet Design
djr@... http://www.newcoast.com and Integration
I found an easy way to remove the encoder disk!
I used small wire clippers to snip off the individual clips of the retaining washer, removed it and then I soaked the end of the
motor shaft with the encoder disk attached in acetone for about 10 minutes. You can then lift the encoder disk off the shaft very
easily with a couple of razor blades, one on each side between the encoder disk and the thick washer attached to the motor shaft.
The acetone does a great job a loosening the glue and does not seem to hurt the encoder disk itself.
- Dan
marble_h@... wrote:
> where does one find one. I would like to try one and see how it works--
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
Daniel Rubin, (614) 457-5919 - Web Site Hosting
President, Newcoast Communications, Inc. - Email Services
- Intranet Design
djr@... http://www.newcoast.com and Integration
Discussion Thread
djr@n...
2000-08-15 09:47:55 UTC
Re: [CAD_CAM_EDM_DRO] Goldmine servos
djr@n...
2000-08-15 09:54:31 UTC
Re: [CAD_CAM_EDM_DRO] Goldmine servos
wanliker@a...
2000-08-15 15:31:15 UTC
Re: [CAD_CAM_EDM_DRO] Goldmine servos
djr@n...
2000-08-15 15:40:11 UTC
Re: Goldmine servos
James Cullins
2000-08-15 15:45:49 UTC
Re: [CAD_CAM_EDM_DRO] Goldmine servos
Mike Gann
2000-08-15 15:59:35 UTC
Re: [CAD_CAM_EDM_DRO] Goldmine servos