Re: Still lurking
Posted by
Jonty50@x...
on 1999-06-17 15:44:12 UTC
In a message dated 6/17/99 0:51:30 AM EST, rhj-rbj@... writes:
<< By all means have some other threads going afterall I want to know about
guideways rods ballscrews and etc to decide what to use. Any recommendations
for starters (routing sheet metals brass, aluminium and plastics abs,acrylics
and styrene mostly for model components in 1:72 and 1:24 scales).
Keep up the terrific work everyone.
diameter hardened rod. If you route or saw a groove just over 1/8" deep and
just under 1/4" wide in heavy aluminum bar or rectangular tube you can press
the rod into the aluminum. I've made several sets of linear bearings this way
now and it works quite nicely..
Jon Croad
jonty50@...
<< By all means have some other threads going afterall I want to know about
guideways rods ballscrews and etc to decide what to use. Any recommendations
for starters (routing sheet metals brass, aluminium and plastics abs,acrylics
and styrene mostly for model components in 1:72 and 1:24 scales).
Keep up the terrific work everyone.
>>I like the Bishop Wisecarver "Dual V" grooved bearings running on 1/4"
diameter hardened rod. If you route or saw a groove just over 1/8" deep and
just under 1/4" wide in heavy aluminum bar or rectangular tube you can press
the rod into the aluminum. I've made several sets of linear bearings this way
now and it works quite nicely..
Jon Croad
jonty50@...
Discussion Thread
Raynor Johnston
1999-06-16 22:45:00 UTC
Still lurking
Tim Goldstein
1999-06-16 23:35:09 UTC
Re: Still lurking
TADGUNINC@x...
1999-06-17 06:48:59 UTC
Re: Still lurking
Tim Goldstein
1999-06-17 09:06:23 UTC
Re: Still lurking
Jonty50@x...
1999-06-17 15:44:12 UTC
Re: Still lurking