CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Goldmine servo's plus books

Posted by Mike Gann
on 2000-08-20 15:22:22 UTC
John -

I ordered some on Aug.15th and I just checked and the
status shows fullfilled. I have not yet received them.

Mike

John Stevenson wrote:
>
> List,
> On the 21st of July I ordered 6 of the small servo motors from Goldmine.
> Not the 1000 count ones as they had already sold out but the 400 count ones
> #2041 at $4.25 each.
> The order was processed and confirmed by email. I checked up on this at
> intervals but the status always said "Unfulfilled"
> I queried this three time with Goldmine but had no replies.
> Tonight the status reads "Canceled"
>
> Has anyone else had trouble with these people?
>
> On a better note someone on this list pointed out a book called Mechanisms
> and Mechanical Devices Sourcebook that was listed on Amazon.com for about
> $85.
> I did a quick search on http://www.abebooks.com and found one at Boulder
> books in Colorado for $35. Ordered it on the 8th and received it well
> packed and in perfect condition on Friday the 18th.
> Very pleased with the service and this is the third time that abebooks have
> found a book for me.
> --
>
> Regards,
> John Stevenson
> Nottingham, England
>
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager

Discussion Thread

Mike Gann 2000-08-20 15:22:22 UTC Re: [CAD_CAM_EDM_DRO] Goldmine servo's plus books JanRwl@A... 2000-08-20 17:44:54 UTC Re: [CAD_CAM_EDM_DRO] Goldmine servo's plus books Stan Stocker 2000-08-20 19:57:27 UTC Re: [CAD_CAM_EDM_DRO] Goldmine servo's plus books Ron Ginger 2000-08-21 06:51:51 UTC Re: [CAD_CAM_EDM_DRO] Goldmine servo's plus books