Re: Linux 6.0 - 5.2

Scalione, the motors I picked up are Pac Sci 300 oz-in, 5 amp, and I believe
bipolar. Tim, seems to be real happy with his setup and sounds like no
problems. Go ahead and pick up a couple of Dan's boards and let's get
started........... See you in two weeks.
Happy Trails...........

----- Original Message -----
From: Tim Goldstein <timg@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Saturday, June 19, 1999 12:19 AM
Subject: Re: [CAD_CAM_EDM_DRO] Linux 6.0 - 5.2


> From: "Tim Goldstein" <timg@...>
>
> > -----Original Message-----
> > From: "Dennis Mino" <dmino@...>
> > Tim what exactly are you using the Camtronics stepper controller and EMC
> > on??? I'm sure you had mentioned it in the past....... Also, whose
motors
> > are you using? oz-in.?? So your just coming off the parallel port? What
> > addin card for the servo's?
> > Thanx.
>
>
> If you go to my web site ( http://www.ktmarketing.com ) you will see my
> setup and some of what I am doing. But in a nut shell, I am using a
Shoptask
> 3 in 1 machine and have all 3 axises hooked up so I can run it as a CNC
mill
> or CNC lathe. I am using Superior stepper motor that are rated 550 in/oz
in
> bipolar configuration.
>
> The way it is set up I have a printer cable coming off the parallel port
to
> a junction board I put in the case with the controller electronics. The
> junction board is nothing fancy. It just gives me a place to tie the limit
> and home switch wires along with the step and direction wires to the
printer
> cable. From the junction board the wires for step and direction go right
to
> the controller board and the motors attach directly to that.
>
> If you want to use a servo system with EMC it is set up to use a
Servo-to-GO
> card ( http://www.servotogo.com/ ). This is not used for stepper systems.
>
>
> Tim
> [Denver, CO]
>
>
> ------------------------------------------------------------------------
> ONElist: where real people with real interests get connected.
> http://www.onelist.com
> Join a new list today!
> ------------------------------------------------------------------------
> welcome to CAD_CAM_EDM_DRO@..., an unmodulated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe:
> http://www.onelist.com/unsubscribe/CAD_CAM_EDM_DRO
> bill, List Manager
>