Re: [CAD_CAM_EDM_DRO] VERT MILL CONVERSION
Posted by
Darrell
on 2000-09-04 18:52:03 UTC
----- Original Message -----
From: "Stan Krumme" <skrumme@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Monday, September 04, 2000 12:57 PM
Subject: [CAD_CAM_EDM_DRO] VERT MILL CONVERSION
Once you start using a CNC you will not miss the handles.
Darrell
>
> I hate loosing manual use of ther machine. Any comments on using
> double shafted motors to allow manual hand wheel operation? Do the
> conversions performed by members on this board allow for manual
> operation?
>
> I have a Millrite vert mill. What would be the acceptable range (min
> & max) for stepper motor torque in the X and Y axis? What about the
> Z axis, does it typically use the same motor size & torque??
>
>
> Thanks, Stan K
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>