Re: EMC-Making chips

Jon:

Could we enhance this chart by listing the software path from a CAD
drawing path to controlling the board. List the alternative packages
like:

DXF to Gcode:
BobCAD/CAM
Gcode95

Gcode to stepper motor controller card:
EMC
CADCODE LITE
DESKNC
STEPSTER
DESKAM

Gcode to DC servo motor controller card:
EMC

Control Cards:
Dave's Card; 3 Axis stepper controller; Parallel port connected;
Software supported ??; URL ??, etc.

Could some on correct and amplify these list. Maybe a short description
of the package, where to get package (url), cost of package, and a
rating 1 to 10.

I assume that the above list is not correct but this is what I think I
have read so far.
--
James Buchanan
Lexington, Kentucky (The Blue Grass State) USA
Two Truck Climax Locomotive Operator & Builder