ServoToGo opto isolation
Posted by
emserv@e...
on 2000-09-25 16:12:50 UTC
Hi,
Iam almost ready to connect the STG card into the amps,encoders,etc.
on my Matchmaker mill.The STG hardware manual states that the board
is OPTO-22 compatible , but Iam not sure which I/O`s need isolation
and how to go about it,any information would be greatly appreciated.
Thanks ,Jim.
Iam almost ready to connect the STG card into the amps,encoders,etc.
on my Matchmaker mill.The STG hardware manual states that the board
is OPTO-22 compatible , but Iam not sure which I/O`s need isolation
and how to go about it,any information would be greatly appreciated.
Thanks ,Jim.
Discussion Thread
emserv@e...
2000-09-25 16:12:50 UTC
ServoToGo opto isolation
Matt Shaver
2000-09-25 17:06:16 UTC
Re: [CAD_CAM_EDM_DRO] ServoToGo opto isolation
Jon Elson
2000-09-26 00:01:54 UTC
Re: [CAD_CAM_EDM_DRO] ServoToGo opto isolation