Re: [CAD_CAM_EDM_DRO] TMG CNC retrofit packages

The more popular controller they sell uses the erricson chips set that puts
out 1.7A. As I recall it uses a connector for the parallel port in the case.
You would have to either open up the case to reconfigure the db25 pins or
you would need an adapter that plugs between the parallel port cable and the
connector on their controller. You can buy this adapter at radio shack for
about $9 but would have to solder the leads to match the EMC output pin
configuration to the TMG pin configuration..
Dan
-----Original Message-----
From: Rich <ibrich2000@...>
To: CAD_CAM_EDM_DRO@egroups.com <CAD_CAM_EDM_DRO@egroups.com>
Date: Monday, October 09, 2000 8:04 PM
Subject: [CAD_CAM_EDM_DRO] TMG CNC retrofit packages

>Dear list,
>
>Is anyone familiar with The Motion Group of San Jose, California? I
>searched the old messages and only found a mention of them in two.
>http://www.motiongroup.com/cnc.htm
>
>Does anyone have one of their controllers and will it work with EMC? I
>asked them and they didn't know what EMC was. Their stuff uses a DOS
>program. They suggested I call and talk to them, just haven't had a
>chance.
>
>TIA,
>
>Richard
>
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@egroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
>List owner: CAD_CAM_EDM_DRO-owner@egroups.com, wanliker@...
>Moderator: jmelson@... [Moderator]
>URL to this page: http://www.egroups.com/group/CAD_CAM_EDM_DRO
>FAQ: http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>
>