Re: [CAD_CAM_EDM_DRO] Disposing of Cutting Oils

Evaporate the water out of it then try the oil bank with
small amounts.
Darrell

----- Original Message -----
From: "Paul Corner" <Paul.Corner@...>
To: <CAD_CAM_EDM_DRO@egroups.com>
Sent: Thursday, October 12, 2000 3:07 PM
Subject: [CAD_CAM_EDM_DRO] Disposing of Cutting Oils


>
> Hi All.
>
> It's time I changed the soluble oil in my mill and
lathe - Going to try one
> of the neat fluids.
> Question is, what do I do with some eight imperial gallons
of the old stuff ?
> Pouring it down the drain is NOT an option, and the local
oil bank isn't going
> to like it. So is there an alternative ?
>
> Regards, Paul.
>
>
> -------------------------- eGroups
Sponsor -------------------------~-~>
> eLerts
> It's Easy. It's Fun. Best of All, it's Free!
> http://click.egroups.com/1/9699/4/_/423600/_/971393986/
> ----------------------------------------------------------
-----------_->
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list
for the discussion of shop built systems, for CAD, CAM, EDM,
and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@egroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@egroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@egroups.com
> List owner: CAD_CAM_EDM_DRO-owner@egroups.com,
wanliker@...
> Moderator: jmelson@... [Moderator]
> URL to this page:
http://www.egroups.com/group/CAD_CAM_EDM_DRO
> FAQ: http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>