Re: [CAD_CAM_EDM_DRO] Re: old sherline Y travel
Posted by
ptengin@a...
on 2000-10-18 20:37:13 UTC
In a message dated 10/18/00 3:12:49 PM Hawaiian Standard Time, KM6VV@...
writes:
<< Circular interpolation would be fine, if I could swing all the way
around the part! 2 or 3" throat/travel is quite limiting! Oh for a 2X
Sherline Mill! Thought about the EMCO FB-2, that would REALLY kill my
budget! And a Myford-7 and a...
Ironically, the RF-45 cost less than my FB-2. And it travels twice as far
in X and Y, 1.5 times in Z so it has a cut volume six times larger. Good
value for the dollar. R-8 vs. MT #2 is no contest either. I'd love a Myford
though..........
Peter
THRD, Inc.
writes:
<< Circular interpolation would be fine, if I could swing all the way
around the part! 2 or 3" throat/travel is quite limiting! Oh for a 2X
Sherline Mill! Thought about the EMCO FB-2, that would REALLY kill my
budget! And a Myford-7 and a...
>>Alan,
Ironically, the RF-45 cost less than my FB-2. And it travels twice as far
in X and Y, 1.5 times in Z so it has a cut volume six times larger. Good
value for the dollar. R-8 vs. MT #2 is no contest either. I'd love a Myford
though..........
Peter
THRD, Inc.
Discussion Thread
Alan Marconett KM6VV
2000-10-18 18:11:52 UTC
Re: old sherline Y travel
ptengin@a...
2000-10-18 20:37:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: old sherline Y travel
ballendo@y...
2000-10-18 21:45:20 UTC
re:Re: old sherline Y travel
Alan Marconett KM6VV
2000-10-18 22:27:17 UTC
Re: old sherline Y travel
Alan Marconett KM6VV
2000-10-18 23:35:19 UTC
Re: old sherline Y travel
Tony Jeffree
2000-10-19 01:09:56 UTC
Re: old sherline Y travel
Alan Marconett KM6VV
2000-10-19 17:57:09 UTC
Re: old sherline Y travel