MiniRobo Drawings
Posted by
Dennis Bohlke
on 2000-10-21 12:46:25 UTC
Thanks for the offer. Please send them to me. I got lots bits to play with
so send both formats and how about a DWG format. I'll put them on the web
page.
Do you know how to load them too the mail list file space? I admit to being
new to using the mail list and I think I saw a post about it but breezed
thru it .
Attached is the source drawing with drawing blocks. It is in version 14,
the little dots are when it was converted from version 13. I haven't edited
it for three years. I am also putting on the web page. Have fun.
http://www.super-tech.com/root/minirobo.htm
I made the MiniRobo with my computerized routers. The drawings were
converted to HPGL file and then used as cutting paths. The different layers
represent different cutting depths.
The puzzle is to figure out what layer is at what depth. I can't remember
right now.
Thanks and best of luck.
Dennis
Best Regards
Dennis
http://www.super-tech.com
so send both formats and how about a DWG format. I'll put them on the web
page.
Do you know how to load them too the mail list file space? I admit to being
new to using the mail list and I think I saw a post about it but breezed
thru it .
Attached is the source drawing with drawing blocks. It is in version 14,
the little dots are when it was converted from version 13. I haven't edited
it for three years. I am also putting on the web page. Have fun.
http://www.super-tech.com/root/minirobo.htm
I made the MiniRobo with my computerized routers. The drawings were
converted to HPGL file and then used as cutting paths. The different layers
represent different cutting depths.
The puzzle is to figure out what layer is at what depth. I can't remember
right now.
Thanks and best of luck.
Dennis
Best Regards
Dennis
http://www.super-tech.com