Re: [CAD_CAM_EDM_DRO] Futaba DRO
Posted by
Carey L. Culpepper
on 2000-10-24 06:27:09 UTC
Joe: Are you sure that it is the scale that is not working? Try
switching the known working scale lead to the connection of the non
working axis. I ran into this after working on a scale for several
hours. It was the readout that had a problem on that axis.
switching the known working scale lead to the connection of the non
working axis. I ran into this after working on a scale for several
hours. It was the readout that had a problem on that axis.
Discussion Thread
Joe Vicars
2000-10-24 04:42:22 UTC
Futaba DRO
Carey L. Culpepper
2000-10-24 06:27:09 UTC
Re: [CAD_CAM_EDM_DRO] Futaba DRO
Joe Vicars
2000-10-24 06:36:18 UTC
Re: [CAD_CAM_EDM_DRO] Futaba DRO